lite-on electronics,inc. property of lite-on only features * dual color chip led. * package in 8mm tape on 7" diameter reels. * compatible with automatic placement equipment. * compatible with infra red and vapor phase refl ow solder process. * eia std package. * i.c. compatible. package dimensions devices part no. lens source color water clear gap on gap green LTST-C195GYKT water clear gaasp on gap yellow notes: 1. all dimensions are in millimeters (inches). 2. tolerance is 0.1mm (.004") unless otherwise noted. part no. : LTST-C195GYKT page : 1 of 6 bns-od-c131/a4
lite-on electronics,inc. property of lite-on only absolute maximum ratings at ta=25 c parameter LTST-C195GYKT unit green yellow power dissipation 100 60 mw peak forward current (1/10 duty cycle, 0.1ms pulse width) 120 80 ma continuous forward current 30 20 ma derating linear from 50 c 0.6 0.4 ma/ c reverse voltage 5 5 v operating temperature range -55 c to + 85 c storage temperature range -55 c to + 85 c wave soldering condition 260 c for 5 seconds infrared soldering condition 260 c for 5 seconds vapor phase soldering condition 215 c for 3 minutes su gg est ir reflow condition : part no. : LTST-C195GYKT page : 2 of 6 bns-od-c131/a4
lite-on electronics,inc. property of lite-on only electrical / o p tical characteristics at ta=25 c LTST-C195GYKT parameter symbol green yellow unit test condition min. 5.0 1.8 typ. 10.0 4.5 luminous intensity iv max. mcd if = 20ma note 1 viewing angle 2 1/2 typ. 130 130 deg note 2 (fig.6) peak emission wavelength p typ. 565 585 nm measurement @peak (fig.1) dominant wavelength d typ. 569 588 nm note 3 spectral line half-width ? typ. 30 35 nm typ. 2.1 2.1 forward voltage vf max. 2.6 2.6 v if = 20ma reverse current ir max. 100 100 a vr = 5v capacitance c typ. 35 30 pf vf=0, f=1mhz notes: 1. luminous intensity is measured with a light sensor and filter combination that approximates the cie eye-response curve. 2. 1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity. 3. the dominant wavelength, d is derived from the cie chromaticity diagram and represents the single wavelength which defines the color of the device. part no. : LTST-C195GYKT page : 3 of 6 bns-od-c131/a4
lite-on electronics,inc. property of lite-on only typical electrical / optical characteristics curves (25 c ambient temperature unless otherwise noted) part no. : LTST-C195GYKT page : 4 of 6 bns-od-c131/a4
lite-on electronics,inc. property of lite-on only cleaning do not use unspecified chemi cal liquid to clean led they could harm the package. if clean is necessary, immerse the led in ethy l alcohol or in isopropyl al cohol at normal temperature for less one minute. suggest soldering pad dimensions package dimensions of tape and reel notes: 1. all dimensions are in millimeters (inches). part no. : LTST-C195GYKT page : 5 of 6 bns-od-c131/a4
lite-on electronics,inc. property of lite-on only notes: 1. empty component pockets s ealed with top cover tape. 2. 7 inch reel-4000 pieces per reel. 3. the maximum number of consecutive missing lamps is two. 4. in accordance with ansi/eia 481-1-a-1994 specifications. part no. : LTST-C195GYKT page : 6 of 6 bns-od-c131/a4
|